Dyson vacuum cleaners are commendable for their powerful suction power. If you are researching the best vacuum cleaners on the market, you must have come across Dyson vacuum suggestions more than enough times now.
Today, we want to focus our attention on the ability of Dyson vacuums to blow out air and not sucking it up. The blower function of vacuum cleaners helps unsettle dust on hard-to-reach places, remove spider webs from corners, act as a leaf blower, and clean CPU cabinets. So,
Can Dyson Vacuum Blow Air?
Dyson vacuums are not designed with blower attachments to quickly turn them into a blower. Also, the cyclonic technology, pre, and post-exhaust filters will interfere with blowing out with the motor in its original position. To use a Dyson vacuum as a blower, you must take it apart.
Suppose you have a lot of cleaning that requires blowing. In that case, you can either purchase a blower or vacuum brand with a blower attachment, which means a dent on your pocket and especially if you had just purchased the expensive Dyson vacuums.
If your finances cannot allow you to make another purchase, consider turning your Dyson vacuum into a blower, as guided in the next section.
How To Convert A Dyson Vacuum Into A Blower
Turning your vacuum cleaner into a blower
allows you to multitask and save money that would have been used to purchase a blower. It saves on storage space too, because you will have less equipment.
Below are simple steps on how to turn a vacuum cleaner into a blower.
1. Prepare Required Tools
The procedure of switching your Dyson vacuum cleaner to a blower is simple, but you require simple equipment, including a user manual, screwdriver, and duct tape.
Among the three, the user manual is a must-have. Since you will be dismantling the vacuum cleaner, it is crucial to follow the manufacturer’s guidelines.
Note that each vacuum cleaner is different, even if from the same brand. Therefore, take time to read through the locations of the parts and how to take them apart to avoid damaging your vacuum.
2. Take Safety Precautions
Vacuum cleaners are electrical appliances, and a simple mistake could result in fatal electric accidents leaving you in the hospital or leave you with a damaged vacuum.
Some of the safety precautions include:
- Always turn off and unplug the vacuum cleaner to avoid electrocution
- Be careful not to break vacuum parts. Some of these parts might appear small, but the vacuum cleaner cannot function without them.
- Depending on where you will be using the blower, ensure that the vacuum cord does not come into contact with water to prevent electrocution or short-circuiting.
- Watch out not to scratch or cut the cord as you dismantled it.
3. Remove The Motor
With tools ready and safety in check, the next step is to remove the motor. Locate the motor housing and remove it carefully with the help of your screwdriver.
Be careful to note the steps of removing the motor because you will need that knowledge to take it in situ.
Note that every vacuum cleaner is different, and you need the help of the user manual of the Dyson vacuum model you are using to remove the motor safely.
After removing the housing, remove the motor by carefully unplugging the connected wires. The connection points are clear, and you are unlikely to miss them.
4. Insert The Vacuum Hose Into The Outlet Port
Usually, canister vacuums have two points of airflow. The inlet used to suck in dirt and the outlet that blows air out.
To turn your vacuum into a blower, you should fix the hose into the outlet.
To achieve this, remove the vacuum hose from the inlet hole and carefully insert it into the outlet hole using duct tape, and seal it completely.
Take the vacuum cleaner outside or to the garage and turn it on to remove the debris build-up. Once it is clear, you can now use it as a blower.
The reverse of these steps will turn your now blower into a vacuum cleaner.
Frequently Asked Questions
Can A Dyson Vacuum Be Used As A Leaf Blower?
Dyson vacuum cleaners do not have the blower attachment, but you can switch it to a leaf blower by dismantling it. Carefully remove the motor, detach the vacuum hose and insert it tightly into the exhaust port to make it a blower.
In Conclusion, Can A Dyson Vacuum Blow Air?
Using the steps above, you can quickly reverse the airflow of your Dyson vacuum cleaner. Important to note, before taking apart your vacuum cleaner, take time to read the user manual to familiarize yourself with the location of different parts and understand guidelines on how to remove them.